Off the oil truck for good
Oil and Gas Heating Replacement in Nahant
Trade a worn boiler or furnace for winter-rated heat pumps. The old unit comes out, goes dark or stays as a backup on controls, whichever the rebate rules and the house call for.
Retire the Boiler on Your Schedule
The best time to switch is when the boiler is already wheezing. You are going to spend money on heat either way. Putting it toward a heat pump means a single system doing both seasons, the end of the oil truck, and a rebate plus 0% financing that can lower what you pay up front.
The question is what happens to the old system. There are two clean answers. Remove or disconnect it, so the heat pump carries the whole house. Or keep it as a backup, wired to integrated controls so it fires up only on the rare bitter nights. Which one fits depends on the house, the heat loss, your comfort with the change and the rebate path you are on. The program has rules here, and we design to them.
Gas and propane homes follow the same logic. A furnace with good ductwork may hand off to a ducted heat pump. A boiler with radiators often pairs with ductless heads. Either way, you get a written plan showing the equipment, what happens to the old unit, the rebate estimate and the loan amount before any work begins.
What a Replacement Covers
The steps between the old boiler and a working heat pump.
System assessment
The age and condition of the boiler or furnace, the distribution system and the electrical panel reviewed.
Heat-loss sizing
A room-by-room count so the heat pump can carry the house without the old system leaning in.
Removal or disconnection
Pulled out or shut off cleanly once the new equipment is carrying that part of the house.
Integrated backup controls
If the boiler stays, controls that let it fire only on the bitterest nights, per program rules.
Tank planning
A plan for the oil tank once deliveries stop, handled in the right order with the rest of the job.
Rebate and loan alignment
The replacement scoped so the rebate rules are met and the HEAT Loan paperwork matches the work.
How a Swap Is Sequenced
Inspect
A look at the burner, the pipes or ductwork and the electrical panel, followed by a heat-loss tally.
Decide
Remove, disconnect or keep as backup. You pick, and the choice goes on paper next to the costs.
Switch
New units in, old unit dealt with per the plan, controls programmed and shown to you.
Reasons Owners Swap With Us
Backup done to the rules
The boiler is pulled or tied to integrated controls exactly as the rebate rules spell out.
A plan you can read
What comes out, what goes in and what it costs after the rebate, all in one written proposal.
Planning hours that fit
Phones open afternoons and evenings every day, so the decision does not wait for a weekday off.
- Oil, propane and gas
- Old unit removed or controlled
- Rebate rules followed
- 0% financing available
Thinking About Your Last Oil Delivery?
Tell us the age of the boiler or furnace, the fuel and how the heat reaches each room. We will outline the switch, the rebate and the loan, step by step.